Torqeedo Ultralight 402, Руководство по эксплуатации, Страница: 46 / 64

46
Operating Manual Ultralight 402
Deutsch
English
8.2 Commissioning the tilting device
1. Mount a clamp block at the level of the driver’s
seat. The clamp block must be aligned to provide
a line that prevents pulls towards the rear of the
kayak.
2. Cut the supplied line to 2 x 3 m (10’’) and 2 x 0.5 m (2.5’’). Melt the ends.
3. Firmly tie one of the 3 m (10’’) lines to the top of the swing arm. Guide the line
through the loop on the ball clamp and fix it in the clamp block. In this way you have
the opportunity to tip the motor out of the water and to hold it in the tipped position.
4. If you want to use the motor in reverse, mount the second clamp block and guide the
line to the lower end of the pivot arm. This protects the motor from undesired tilting up.
8.3 Attaching the steering
The following steps are only relevant if you want to connect the motor to the kayak’s
steering system.
1. If you want to connect the motor with the kayak’s steering system instead of the
rudder:
Fix the lines from the kayak’s steering with the triangular clamp ring at the
upper end of the motor shaft. Extend the lines for the kayak’s steering as far as
necessary, if appropriate you can use the supplied karabiner hooks to fix the lines
to the clamp ring.
1.
2.