Toro Z Master 74028, Руководство оператора

Страница: 29 / 76

Adjusting the Height of Cut
Adjust the height of cut from 25 to 140 mm (1 to 5-1/2
inches) in 6 mm (1/4 inch) increments by moving the
clevis pin into different hole locations.
1. With the engine running, push the deck-lift
switch rearward until the mower deck is fully
raised, and release the switch immediately.
2. Rotate the height-of-cut pin until the roll pin
in it lines up with the slots in the holes in the
height-of-cut bracket and remove it (
Figure 24 ).
3. Insert the height-of-cut pin into the hole
corresponding to the desired cutting height
(
Figure 24 ).
Refer to the decal on the side of the deck-lift
plate for the heights of cut (
Figure 24 ).
4. Using the deck-lift switch, move the deck height
out of the transport position (or 5-1/2 inches (140
mm) cutting height) and down to the selected
height.
g227689
Figure 24
1. Height-of-cut bracket 2. Height-of-cut pin
Adjusting the Anti-Scalp
Rollers
For maximum deck flotation, install the rollers 1 hole
position lower. Rollers should maintain a 6 mm (1/4
inch) clearance to the ground. Do not adjust the
rollers to support the deck.
1. Park the machine on a level surface.
2. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
EUTRAL
-
LOCK
position, and engage the parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Adjust the anti-scalp rollers as shown in Figure
25 , Figure 26 , Figure 27 , and Figure 28 .
g227785
Figure 25
1. Flange nut 3. Bushing
2. Anti-scalp roller 4. Bolt
29