Cleaning
Cleaning the Engine and
Exhaust System Area
Service Interval:
Before each use or daily—Clean the
engine and exhaust system area.
Important:
Do not use water to clean the engine.
Use low-pressure compressed air. See the engine
owner's manual.
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean around the flywheel, cylinder head,
injectors, and injector pump.
4.
Clean all debris from the exhaust system area.
5.
Wipe up any excessive grease or oil around the
engine and exhaust area.
Cleaning the Machine and
Mower Deck
Service Interval:
Before each use or daily
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Clean off any oil, debris, or grass build-up on
the machine and mower deck, especially under
the deck-belt shields, around the fuel tank, and
around the engine and exhaust area.
4.
Raise the mower deck to the T
RANSPORT
position.
5.
Clean out any grass build-up from the underside
of deck and in the discharge deflector.
Disposing of Waste
Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
Storage
Storage Safety
•
Shut off the engine, remove the key, wait for all
moving parts to stop, and allow the machine to
cool before storing it.
•
Do not store the machine or fuel near flames or
drain the fuel indoors.
•
Remove the key and store it in a safe place out
of the reach of children.
Cleaning and Storage
1.
Disengage the blade-control switch (PTO), and
engage the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure
wash the machine. Avoid excessive use
of water, especially near the control panel,
engine, hydraulic pumps, and motors.
4.
Check the parking brake operation; refer to
Operating the Parking Brake (page 24)
.
5.
Service the air cleaner; refer to
.
6.
Grease the machine; refer to
.
7.
Change the crankcase oil; refer to
Engine Oil (page 43)
.
8.
Check the tire pressure; refer to
Tire Pressure (page 49)
.
9.
Change the hydraulic filters; refer to
the Hydraulic Fluid and Filter (page 59)
.
10.
Charge the battery; refer to
(page 47)
.
11.
Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
12.
Check the condition of the blades; refer to
Servicing the Cutting Blades (page 60)
.
67
Содержание Z Master 74028
Страница 74: ...Notes...
Страница 76: ......
