Toro TX 427 22342HD, Руководство оператора

Страница: 30 / 52

1 2
3
4
5
6
G018430
Figure 36
1. Hose clamp 4. Air filter
2. Hose to carbon canister 5. Purge-line filter
3. Carbon canister 6. Rear access door
4. Install a new filter onto the carbon canister ( Figure 36 ).
5. Install the rear-access cover; see Closing the
Rear-Access Cover (page 27) .
Replacing the Carbon-Canister
Purge-line Filter
Service Interval: Every 200 hours—Replace the
carbon-canister purge-line filter
(Service more frequently when using the
vibratory plow attachment).
Note:
Check the purge-line filter occasionally for dirt. If the
filter appears to be dirty, replace it.
1. Lower the loader arms, shut off the engine, and remove
the key.
2. Remove the rear-access cover; see Opening the
Rear-Access Cover (page 26) .
3. Move the spring-type hose clamps on both sides of the
carbon-canister purge-line filter away from the filter
(
Figure 36 ).
4. Remove and discard the purge-line filter ( Figure 36 ).
5. Install a new filter into the hose with the arrow on
the filter pointing away from the carbon canister and
secure it with the hose clamps (
Figure 36 ).
6. Install the rear-access cover; see Closing the
Rear-Access Cover (page 27) .
Servicing the Engine Oil
Service Interval: After the first 50 hours
Every 100 hours—Change the engine oil.
Every 200 hours—Change the oil filter.
Note:
Change the oil and filter more frequently when
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SG, SH, SJ, or higher)
Crankcase Capacity: with filter, 2.0 L (2.1 US qt)
Viscosity: See table below
G005564
Figure 37
Changing the Oil
1. Start the engine and let it run for 5 minutes. This
warms the oil so that it drains better.
2. Park the traction unit so that the drain side is slightly
lower than the opposite side to ensure that the oil
drains completely.
3. Lower the loader arms, set the parking brake, shut off
the engine, and remove the key.
CAUTION
Components will be hot if the traction unit has
been running. If you touch hot components,
you may be burned.
Allow the traction unit to cool before
performing maintenance or touching
components under the hood.
4. Remove the drain plug ( Figure 38 ).
30