Toro timecutter zs 4200t, Руководство оператора

Страница: 25 / 60

G010233
1
2
3
4
Figure 21
1. Anti-scalp roller 3. Flange nut
2. Bolt 4. Hole spacing
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable (
Figure 22 ).
g027249
B
C
A
Figure 22
Adjusting the Motion-Control
Levers
Adjusting the Height
The motion-control levers can be adjusted higher or lower for
maximum operator comfort (
Figure 23 ).
g027252
B
A
Figure 23
Adjusting the Tilt
The motion-control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control-arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft (
Figure 23 ). Tighten both bolts to
secure the control in the new position.
3. Repeat the adjustment for the opposite control lever.
Pushing the Machine by Hand
Important:
Always push the machine by hand. Do not
tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and to push
the machine, the ignition key needs to be in the Run position.
The battery needs to be charged and functioning for the
electric brake to be disengage.
Pushing the Machine
1. Park the machine on a level surface, and disengage the
blade-control switch.
2. Move the motion-control levers outward to the park
position, stop the engine, and wait for all moving parts
to stop before leaving the operating position.
3. Locate the bypass levers on the frame on both sides of
the engine.
4. Move the bypass levers forward through the key hole
and down to lock them in place (
Figure 24 ).
25