Toro TimeCutter 74706, Руководство оператора

Страница: 46 / 56

g014634
Figure 57
1. Adjusting rod 3. Locknut
2. Adjusting block
7. To raise the front of the mower, tighten the
adjustment nut.
8. To lower the front of the mower, loosen the
adjustment nut.
9. After adjustment, check the front-to-rear slope
again, continue adjusting the nut until the front
blade tip is 1.6 to 7.9 mm (1/16 to 5/16 inch)
lower than the rear blade tip (
Figure 56 ).
10. When the front-to-rear blade slope is correct,
check the side-to-side level of the mower again;
refer to
Leveling from Side to Side (page 44) .
Removing the Mower Deck
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest
position.
4. Remove the hairpin cotter from the front support
rod, and remove the rod from the deck bracket
(
Figure 58 ).
g014635
Figure 58
1. Front support rod 3. Deck bracket
2. Locking nut
5. Carefully lower the front of the mower deck to
the ground.
6. Lift the mower deck and hanger brackets clear
of the rear lift rod and lower the mower carefully
to the ground (
Figure 59 ).
g005077
Figure 59
1. Mower deck 3. Rear lift rod
2. Hanger bracket
7. Slide the mower deck rearward to remove the
mower belt from the engine pulley.
46