3-16
WPM Drive Systems Manual
SINGLE SPEED BEVEL GEAR TRANSMISSION
2. Since the pulley was previously removed, the input
shaft will now slip out of the transmission case.
3. If the input bearing is to be removed, press it out
now.
4. Slide the bearings and thrust washer off the axle.
Drive the roll pin out and the bevel gear can be
removed (Fig. 083).
Fig 083
MVC-470
Assemble in reverse order.
Transmission Assembly
Transmission Disassembly
6. You can now release the clamps and separate the
HOC plate, spring arm, and pivot arm (Fig. 081).
Fig 081
MVC-750
Fig 082
MVC-462
1. Remove the 4 screws holding the cover on the
transmission. The axle, bearings, and bevel gear
can be lifted out (Fig. 082).
Содержание Recycler 20012
