Toro Recycler 20012, Руководство по обслуживанию

Страница: 130 / 144

7-10 WPM Drive Systems Manual
HANDLES AND CONTROL CABLES
2. Squeeze the ends of the upper bail to disengage
them from the handle. On some models the right
side of the bail may be connected to the pin by a
push nut. The push nut can be removed or the bail
removed with the pin attached (Fig. 247).
Fig 247 DSC-4871a
3. Remove the shoulder bolt and the traction lever (Fig.
248).
Fig 248 DSC-4880a
4. Slide the pin out of the left hand handle and pull the
upper handle up and out.
5. The plastic sleeves will slide off the upper handle.
6. The springs can be removed from the top slides if
necessary.
If the handle has been binding, clean the top slides and
the sleeves before assembling. Dirt and grit in the sliding
part of the handle can cause a bind.
Assemble in reverse order. When you install the upper
handle, line up the holes and install the pivot pins (Fig.
249).
Fig 249 DSC-4885a
Assembly