7-11
WPM Drive Systems Manual
HANDLES AND CONTROL CABLES
The engine brake cable is not adjustable. If it fails to
function it will need to be replaced.
Fig 251
G002634
Fig 250
G002635
To properly adjust the self propel cable, loosen the cable
clamp, pull the cable downward to remove all the slack
(Fig. 250) then push the cable jacket up 1/8” (3.17cm)
(Fig. 251) and secure with the cable clamp.
Cable Adjustment
Self-Propel Cable
Handle Disassembly, Lawn-Boy Blade
Clutch System (BCS) Models
1. Remove the upper wire bail. On the right hand side
it slides over a pin. On some models this pin has a
push nut on it (Fig. 252). It can be compressed so
that either the bail slides off the pin or it draws the
pin out of the handle. Either is acceptable.
Fig 252
DSC-4871a
1. Cable
1. Cable
clamp
2. Cable
Содержание Recycler 20012
