Toro Recycler 20012, Руководство по обслуживанию

Страница: 72 / 144

4-8 WPM Drive Systems Manual
THREE SPEED TRANSMISSION
Output Shaft Assembly
1. Slide the output bushing onto the output shaft,
fl anged side last. Assemble from the end of the shaft
closest to the hole for the roll pin.
2. Slide the gear sleeve onto the output shaft, tabs last
and secure with a new roll pin.
3. Apply a light coat of lithium-based grease on the
output shaft under the output busing, on the gear
sleeve, and on the three output shaft gears. Slide
the three output shaft gears onto the gear sleeve,
notched sides last.
4. Slide the nylon shift key sleeve onto the output shaft,
large end fi rst. Make sure that it engages the tabs on
the gear sleeve (Fig. 123).
Fig 123 492-4733 fi g. 4-1
A. Shift key sleeve
Fig 125 3428-0066
6. Slide the shift key assembly into the shift key sleeve
until the shift collar bottoms out.
7. Complete the output shaft assembly by sliding a
spacer washer and the other output bushing, fl anged
side fi rst, onto the output shaft. Don’t forget to coat
these components with a light coat of grease (Fig.
125).
Fig 124 3428-0065
5. Coat the shift key sleeve with grease and prepare
the shift keys, shift collar, and spring clip for
assembly as shown in Figure 124.
A