1-5
WPM Drive Systems Manual
Fig 008
3428-0137
7. The wheel pinion, thrust washer, pivot, and spring
arm will now slide off the end of the axle (Fig. 008).
Repeat the process on the other side.
Fig 007
3428-0135
6. Place a block of wood under the wheel pinion for
support and drive the roll pin out of the axle (Fig.
007). Repeat the process on the other side.
8. Remove the transmission from the chassis.
9. Reverse the procedure to install.
NOTE: Support the wheel pinions with the wood
block while driving the roll pins in. This will
prevent the axle from being bent. Fill the
transmission with oil after it is installed in
the mower (Fig. 009).
Note the front of the transmission is identifi ed by the oil
fi ll/check screw and the fl at tab which is part of the lower
case.
Fig 009
3428-0166
WORM DRIVE TRANSMISSION
Disassembly
1. Cut and discard the push-on retainer on top of the
transmission pulley. Remove the belt and pulley.
A. Wood
Block
A. Fill/Check
C. Tab
B. Plug
A
A
B
A
C
Содержание Recycler 20012
