Toro Pro Force 44554, Руководство оператора

Страница: 24 / 36

Changing the Oil
Service Interval: Every 100 hours
1. Start the engine and let it run 5 minutes. This
warms the oil so that it drains better.
2. Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the
oil drains completely.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Place a pan below the drain. Rotate the oil drain
valve to allow the oil to drain (
Figure 18 ).
Note:
Insert a hose may be inserted onto the
drain valve to direct the oil flow. The hose is not
included with the machine.
5. When the oil has drained completely, close the
drain valve.
Note:
Dispose of the used oil at a recycling
center.
g002148
Figure 18
1. Oil drain valve 2. Oil drain hose ( Not
included )
6. Slowly pour approximately 80% of the specified
oil into the filler tube (
Figure 17 ).
7. Check the oil level; refer to Checking the Engine
Oil Level (page 23) .
8. Slowly add the additional oil to bring it to the
Full mark.
Changing the Oil Filter
Service Interval: Every 200 hours
Note:
Change the oil filter more frequently when the
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing
the Oil (page 24) .
2. Remove the old filter and wipe the filler adapter
gasket surface (
Figure 19 ).
g001056
Figure 19
1. Oil filter 3. Adapter
2. Adapter gasket
3. Apply a thin coat of new oil to the rubber gasket
on the replacement filter (
Figure 19 ).
4. Install the replacement oil filter to the filter
adapter, turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 2/3 to 1 turn
(
Figure 19 ).
5. Fill the crankcase with the proper type of new
oil; refer to
Servicing the Engine Oil (page 23) .
6. Run the engine for about 3 minutes, shut off the
engine, and check for oil leaks around the oil
filter.
7. Check the engine oil level and add oil if needed.
24