Toro Pro Force 44554, Руководство оператора

Страница: 23 / 36

g018506
Figure 15
1. Carbon canister purge-line
filter 2. Check valve
3. Remove and discard the carbon filter ( Figure
15 ).
4. Install a new filter into the hose with the arrow
on the filter pointing towards the check valve
and secure it with the hose clamps (
Figure 15 ).
Servicing the Engine Oil
Note:
Change the oil more frequently when the
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SG, SH, SJ or
higher)
Crankcase Capacity (with filter): 2 L (67 oz)
Viscosity: See the table below.
g000238
Figure 16
Checking the Engine Oil Level
Service Interval: Before each use or daily
Note:
The best time to check the engine oil is when
the engine is cool before it has been started for the
day. If it has already been run, allow the oil to drain
back down to the sump for at least 10 minutes before
checking. If the oil level is at or below the A
DD
mark
on the dipstick, add oil to bring the oil level to the F
ULL
mark. Do not overfill . If the oil level is between the
F
ULL
and A
DD
marks, no oil addition is required.
1. Park the machine on a level surface.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean around the oil dipstick ( Figure 17 ) so that
dirt cannot fall into the filler hole and damage
the engine.
g002359
Figure 17
1. Oil dipstick
2. Filler tube
4. Unscrew the oil dipstick and wipe the end clean
(
Figure 17 ).
5. Slide the oil dipstick fully into the filler tube, but
do not thread it onto the tube (
Figure 17 ).
6. Pull the dipstick out and look at the metal end. If
the oil level is low, slowly pour only enough oil
into the filler tube to raise the level to the F
ULL
mark.
Important:
Do not overfill the crankcase
with oil and run the engine. Engine damage
can result.
23