Toro LT3340, Руководство оператора

Страница: 54 / 64

Contaminated fluid looks milky or black when
compared to clean fluid.
Draining the Hydraulic Fluid
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, engage the
parking brake, and remove the key.
2. Remove the storage compartment; refer to
Removing the Storage Compartment (page 38) .
3. Align a drain pan under the hydraulic tank,
remove the tank drain plug, and fully drain the
hydraulic fluid (
Figure 70 ).
g292488
Figure 70
1. Hydraulic tank 3. Drain plug
2. Seal
4. Install the drain plug with a new seal.
Cleaning the Strainers
1. Remove the oil tank suction flange to gain
access to the suction strainer (
Figure 71 ).
g014452
Figure 71
1. Oil-tank filler cap 3. Filler strainer
2. Suction strainer
2. Unscrew and remove the strainer and clean with
paraffin or petrol before installing (
Figure 71 ).
Hydraulic Fluid Capacity
32 L (8.5 US gallons); refer to Hydraulic Fluid
Specifications (page 52)
Filling the Hydraulic Tank with
Fluid
1. Fill the hydraulic tank with the specified hydraulic
fluid; refer to
Hydraulic Fluid Specifications
(page 52) and Checking the Hydraulic Fluid
Level (page 52) .
Important:
Use only hydraulic fluids
specified; other hydraulic fluids could
damage the system.
2. Run the machine and operate all hydraulic
systems until the hydraulic fluid is warm.
3. Check the fluid level and top up as necessary to
the upper mark on the sight-level gauge.
4. Install the storage compartment; refer to
Installing the Storage Compartment (page 38) .
54