Toro Infield Pro 08712, Руководство оператора

Страница: 9 / 20

new valve and the vacated fitting on the existing
lift valve (
Figure 15 ).
6. Connect the 45-degree fitting end of hydraulic
hose, Part No. 108-8449, to the 90-degree fitting
on the right side of the valve and the straight
end of the hose to the vacant oil cooler fitting
(
Figure 15 ). Refer to Figure 16 and Figure 17
for hose routing.
7. Mount the wire hose holder to the left frame tube
with 2 thread-forming screws (5/16 x 3/4 inch);
refer to
Figure 15 .
8. Connect the short 90-degree fitting end of
hydraulic hose, Part No. 108-8453, to the top
straight fitting on the rear of the valve. Route the
hose through the wire hose holder and connect
the straight end of the hose to the top hydraulic
cylinder fitting ( Figure 15 ). Refer to Figure 16
and Figure 17 for hose routing.
9. Connect the long 90-degree fitting end of the
hydraulic hose, Part No. 108-8454, to the bottom
straight fitting on the rear of the valve. Route the
hose through the wire hose holder and connect
the straight end of the hose to the bottom
hydraulic cylinder fitting (
Figure 15 ). Refer to
Figure 16 and Figure 17 for hose routing.
Important:
Make sure that the hoses are
routed away from any sharp, hot, or moving
components.
10. Tighten all fasteners and fittings.
11. Using cable ties, secure the hoses to the
machine at the locations shown in
Figure 16 and
Figure 17 .
g003672
Figure 15
1. New valve 3. Existing valve 5. Wire hose holder 7. Hydraulic hose (Part No.
108-8454)
2. Tube assembly (Part No.
108-8447) 4. Hydraulic hose (Part No.
108-8449) 6. Hydraulic hose (Part No.
108-8453)
9