Toro Infield Pro 08712, Руководство оператора

Страница: 12 / 20

8
Installing the Control Panel
and Lever Guide Plate
Parts needed for this procedure:
1 Lever guide plate
2 Flange-head screw
2 Washer
1 Control panel decal
1 Control panel
1 Knob
3 Plastic cable tie
Procedure
1. Insert the lever guide plate over the lift lever and
loosely secure it to the frame with 2 flange-head
screws and washers (
Figure 18 ).
g003675
Figure 18
1. Lever guide plate 2. Flange-head screws
2. Check the hydraulic-fluid level and replenish the
fluid as required.
WARNING
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
• If hydraulic fluid is injected into the
skin it must be surgically removed
within a few hours by a doctor familiar
with this type of injury. Gangrene may
result if this is not done.
• Keep body and hands away from
pin hole leaks or nozzles that eject
high-pressure hydraulic fluid.
• Use cardboard or paper to find
hydraulic leaks.
• Safely relieve all pressure in the
hydraulic system before performing
any work on the hydraulic system.
• Make sure that all hydraulic-fluid
hoses and lines are in good condition
and all hydraulic connections and
fittings are tight before applying
pressure to the hydraulic system.
3. Start the traction unit engine and check the
fitting connections.
4. Install the wheel shroud, the center shroud, and
the console.
Note:
Do not install the control panel at this
time. Make sure that the shrouds do the interfere
with the hoses. Route the hoses as required.
Reverse the shroud installation procedure used
in step
1 .
5. Install the rear tire and remove the blocks from
under the rear of the machine.
6. Torque the lugs nuts to 61 to 75 N∙m (45 to 55
ft-lb).
7. With the engine running and lift lever in the Float
position, slide the lever guide plate until the lift
cylinder can be extended and retracted by hand
(
Figure 18 ).
WARNING
The engine must be running so that the
final adjustment of the lift lever detent
plate can be performed. Contact with
moving parts or hot surfaces may cause
personal injury.
Keep hands, feet, face, and other body
parts away from rotating parts, the
muffler, and other hot surfaces.
8. Tighten both lift lever guide plate mounting
screws to secure the adjustment (
Figure 18 ).
12