Toro Infield Pro 08712, Руководство оператора

Страница: 8 / 20

g003669
Figure 12
1. Hydraulic cylinder 3. 45-degree fitting
2. 90-degree fitting 4. Plug (1/8 inch)
3. Mount the top of the hydraulic cylinder barrel
to the pin on the right-hand plow plate with a
retaining ring (
Figure 13 ).
Note:
Position the cylinder hydraulic ports
forward.
g028342
Figure 13
1. Retaining ring 4. Push arm strap
2. Hydraulic cylinder 5. Pin
3. Pin (on plow plate)
4. Mount the cylinder rod to the push arm straps
with a pin and 2 retaining rings (
Figure 13 ).
7
Installing the Hydraulic
Hoses
Parts needed for this procedure:
1 Tube assembly
1 Hydraulic hose (Part No. 108-8449)
1 Hydraulic hose (Part No. 108-8453)
1
Hydraulic hose (Part No. 108-8454)
1 Wire hose holder
2 Thread forming screw (5/16 x 3/4 inch)
3 Plastic cable tie
Procedure
1. Locate the hydraulic tube that goes from the oil
cooler to the existing lift valve (
Figure 14 ).
2. Remove the fasteners and tube clamp securing
the hydraulic tubes to the frame.
3. Disconnect and remove the hydraulic tube from
the oil cooler and the lift valve (
Figure 14 ).
Note:
To minimize oil loss when removing
the hydraulic tube, have the replacement hose
ready or cap the fitting on the cooler using one of
the protective shipping caps removed from the
tube assembly, Part No. 108-8447 (
Figure 15 ).
g003671
Figure 14
1. Oil cooler
2. Hydraulic tube
4. Secure the remaining hydraulic tube to the
frame with the clamp and fasteners previously
removed
5. Connect the tube assembly, Part No. 108-8447,
to the 90-degree fitting on the left side of the
8