Toro Groundsmaster 7210 Series, Руководство оператора

Страница: 57 / 64

WARNING
The engine must be running to perform this
adjustment. Contact with moving parts or hot
surfaces may cause personal injury.
Keep hands, feet, face, clothing, and other
body parts away from rotating parts, muffler,
and other hot surfaces.
1. Raise the frame onto stable jack stands so that
the drive wheels can rotate freely.
2. Slide the seat forward, unlatch it, and swing it up
and forward.
3. Disconnect the electrical connector from the
seat safety switch.
4. Temporarily install a jumper wire across the
terminals in the wire harness connector.
5. Start the engine, ensure that the throttle lever is
midway between the F
AST
and S
LOW
positions,
and release the parking brake.
Note:
The motion-control levers must be in
the N
EUTRAL
-
LOCK
position while you make any
adjustments.
6. Adjust the pump rod length on one side by
rotating the hex shaft, in the appropriate
direction, until the corresponding wheel is still or
slightly creeping in reverse (
Figure 80 ).
g004488
Figure 80
1. Right pump rod 5. Jam nut
2. Left pump rod 6. Hex shaft
3. Ball joint 7. Ball joint
4. Bolt
7. Move the motion-control lever forward and
reverse, then back to neutral.
Note:
The wheel must stop turning or slightly
creep in reverse.
8. Move the throttle lever to the F
AST
position.
Note:
Make sure that the wheel remains
stopped or slightly creeps in reverse; adjust it
if necessary.
9. Repeat steps 6 through 8 for the other side of
the machine.
10. Tighten the jam nuts at the ball joints ( Figure 78 ).
11. Move the throttle lever to the S
LOW
position and
shut off the engine.
12. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
57