Toro Groundsmaster 7210 Series, Руководство оператора

Страница: 27 / 64

Engaging the Power Takeoff (PTO)
The power-takeoff (PTO) switch starts and stops the
mower blades and some powered attachments.
Note:
If the engine is cold, allow the engine to warm
up 5 to 10 minutes before engaging the PTO.
g032826
Figure 28
Disengaging the PTO
G009174
g009174
Figure 29
Adjusting the Height of Cut
You can adjust the height of cut from 2.5 to 15.8 cm
(1 to 6 inches) in 6 mm (1/4 inch) increments by
relocating the stop pin into different hole locations.
1. With the engine running, push the deck-lift
switch up until the mower deck is fully raised and
release the switch immediately ( Figure 27 ).
2. Rotate the stop pin until the roll pin in it lines up
with the slots in the holes in the height-of-cut
bracket and remove it (
Figure 30 ).
3. Select a hole in the height-of-cut bracket
corresponding to the height of cut desired, insert
the pin, and rotate it down to lock it in place
(
Figure 30 ).
Note:
There are 4 rows of hole positions
( Figure 30 ). The top row gives you the height of
cut listed above the pin. The second row down
gives you the height listed plus 6 mm (1/4 inch).
The third row down gives you the height listed
plus 12 mm (1/2 inch). The bottom row gives you
the height listed plus 18 mm (3/4 inch). For the
15.8 cm (6 inch) position, there is only 1 hole,
located in the second row. This does not add
6 mm (1/4 inch) to the 15.8 cm (6 inch) position.
G020870
1
2
g020870
Figure 30
1. Stop pin 2. Height-of-cut stop
4. Adjust the anti-scalp rollers and skids as
required.
27