7.
Route the wire harness through the bracket and under
the operator platform (
).
8.
Connect the wire harness to both connectors that you
unplugged from the existing headlights and connect
the front turn signal connector to the platform wire
harness (
).
9.
Route the wire harness through the left headlight
bracket and connect it to the left headlight (
10.
Install a cover panel to each headlight mount using 4
plugs.
5
Installing the Headlights
(for Machines with a Cab
Only)
Parts needed for this procedure:
1
Right headlight mount
1
Left headlight mount
1
Right headlight assembly
1
Left headlight assembly
2
Bolt (1/2 x 1-1/4 inches)
2
Nut (1/2 inch)
2
Bolt (1/4 x 3/4 inch)
2
Nut (1/4 inch)
6
Cable tie
1
Front wire harness
Procedure
1.
Install each headlight mount to the cab frame using 1
bolt (1/2 x 1-1/4 inches), 1 nut (1/2 inch), 1 bolt (1/4
x 3/4 inch), and 1 nut (1/4 inch) as shown in
.
g035976
Figure 9
1.
Headlight
4.
Nut (1/2 inch)
2.
Bolt (1/2 x 1-1/4 inches)
5.
Bolt (1/4 x 3/4 inch)
3.
Nut (1/4 inch)
6.
Headlight mount
2.
Remove the fasteners from the headlight assemblies
and use them to install the headlights to the mounts.
3.
Connect the wire harness to the right headlight (
g036570
Figure 10
1.
Right headlight connector
4.
Connect to existing left
headlight wire harness.
2.
Connect to existing right
headlight wire harness.
5.
Left headlight connector
3.
Front turn signal connector
4.
Route the wire harness along the bracket and under the
operator platform (
6
