Toro 41355, Руководство пользователя

Страница: 7 / 35

7
WIRING HARNESS INSTALLATION:
1. Connect the Wiring Harness connectors to the
Switches as shown in the WIRING DIAGRAM .
Install the Switches in the holes in the seat support,
as per FIG. 11, using the nuts included with the
Switches. Install the protective rubber Boots. Apply
the “UP/DOWN” decal between the Switches.
2. Connect the push-on terminal on the red wire
coming from the Wiring Harness to the connector
on the red wire coming from the fuse block. Ground
the spade terminal on the black wire to the Ground
Terminal Block. See FIG. 12.
FIG. 11
1. Boom Switches 4. Protective Rubber Boots
2. Decal 5. Wire Harness
3. Nuts
WIRING DIAGRAM
FIG. 12
1. Fuse Block 3. Ground Term. Block
2. Push-On Terminal 4. Spade Terminal
2
4
3
5
1
3
1
2
4
1. Wiring Harness - Vehicle 3. Brake Controller
2. Wiring Harness - Brake Controller 4. Brake Lead - Right
5. Brake Lead - Left
1
3
2
5
4
Starter
Solenoid