Toro 41179, Руководство оператора

Страница: 60 / 68

Troubleshooting the Spray System
Problem Possible Cause Corrective Action
1. The electrical connection on the boom
valve is dirty or disconnected.
1. Turn the valve off manually. Disconnect
the electrical connector on the valve
and clean all leads, then reconnect it.
2. Blown fuse 2. Check the fuses and replace them as
necessary.
3. Pinched hose 3. Repair or replace the hose.
4. A boom by-pass valve is improperly
adjusted.
4. Adjust the boom by-pass valves.
5. Damaged boom valve 5. Contact your Authorized Service
Dealer.
A boom section does not spray.
6. Damaged electrical system
6. Contact your Authorized Service
Dealer.
A boom section does not turn off. 1. The valve is damaged. 1. Stop the spray system and pump
and turn off the sprayer. Remove the
retainer from under the boom valve and
pull out the motor and stem. Inspect
all parts and replace any that appear
damaged.
A boom valve is leaking 1. An O-ring is deteriorated. 1. Stop the spray system and pump and
turn off the sprayer. Disassemble the
valve and replace the O-rings.
1. The boom bypass valve is improperly
adjusted.
1. Adjust the boom bypass valve.
2. There is an obstruction in the boom
valve body.
2. Remove the inlet and outlet connections
to the boom valve and remove any
obstructions.
A pressure drop occurs when you turn on
a boom.
3. A nozzle filter is damaged or clogged. 3. Remove and inspect all nozzles.
1. A thermal breaker in the fuse block
responsible for powering the actuator
has tripped due to overheating.
1. Wait for the system to cool down before
resuming operation. If the thermal
breaker trip repeatedly, contact your
Authorized Service Dealer.
Boom actuator is not operating properly.
2. A thermal breaker in the boom actuator
responsible for powering the actuator
has tripped or malfunctioned.
2. Contact your Authorized Service
Dealer.
Troubleshooting the Spray Pro Monitor
Problem Possible Cause Corrective Action
1. The monitor cable is loose or
disconnected.
1. Connect the monitor cable. The monitor does not function.
2. The monitor or cable is damaged. 2. Contact your Authorized Service
Dealer.
1. The monitor cable is loose. 1. Connect the monitor cable.
2. The speed sensor is not calibrated
correctly.
2. Calibrate the speed sensor.
The Speed is always 0 or erratic.
3. The speed sensor is damaged. 3. Contact your Authorized Service
Dealer.
1. The sprayer width is not correctly
entered.
1. Check and set the appropriate Width in
the calibration mode.
2. The speed sensor is not calibrated
correctly.
2. Calibrate the speed sensor.
The Area is inaccurate.
3. The speed sensor is damaged. 3. Contact your Authorized Service
Dealer.
60