Toro 30643, Руководство оператора

Страница: 53 / 72

6. Through the open hole, slowly fill the planetary with
0.65 L (22 oz) of high quality SAE 85W-140 wt gear
lube.
Important:
If the planetary fills before the 0.65 L
(22 oz) of oil is added, wait 1 hour or install the
plug and move the machine approximately 10 feet
to distribute the oil through the brake system.
Then, remove the plug and add the remaining oil.
7. Install the plug.
8. Repeat the procedure on the opposite planetary/brake
assembly.
Checking the Rear-Axle
Lubricant
Service Interval: Every 400 hours
The rear axle is filled with SAE 85W-140 gear lube. Check
the lubricant level before you first start the engine and as
recommended. The capacity is 2.4 L (80 oz). Visually inspect
for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from the end of the axle and
ensure that the lubricant is up to the bottom of the
hole (
Figure 64 ).
Note:
If the level is low, remove the fill plug and add
enough lubricant to bring the level up to the bottom of
the check-plug holes.
Figure 64
1. Check plug 2. Fill plug
Checking the
Rear-Axle-Gearbox Lubricant
Service Interval: Every 400 hours
The gearbox is filled with SAE 85W-140 gear lube. The
capacity is 0.5 L (16 oz). Visually inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side of the
gearbox and ensure that lubricant is up to the bottom
of the hole (
Figure 65 ).
Note:
If the level is low, add enough lubricant to bring
the level up to the bottom of the hole.
Figure 65
1. Gearbox 2. Check/fill plug
Changing the Rear-Axle
Lubricant
Service Interval: After the first 200 hours
Every 800 hours
1. Position the machine on a level surface.
2. Clean the area around the 3 drain plugs; 1 on each end
and 1 in the center (
Figure 66 ).
3. Remove the check plugs to ease in the draining of the
oil.
4. Remove the drain plugs and allow the oil to drain into
the pans.
53