![Toro 30643 Скачать руководство пользователя страница 26](http://html1.mh-extra.com/html/toro/30643/30643_operators-manual_1133237026.webp)
Figure 16
6.
Push the caster spindle through the front caster arm.
7.
Install the shims (as they were originally installed) and
the remaining spacers onto the spindle shaft.
8.
Install the tensioning cap to secure the assembly.
9.
Remove the hairpin cotter and clevis pin securing the
height-of-cut chains to the rear of the mower deck
(
).
1
2
g020968
Figure 17
1.
Height-of-cut chain
2.
Clevis pin and hairpin
cotter
10.
Mount the height-of-cut chains to the desired
height-of-cut hole with the clevis pin and hairpin cotter
(
).
Figure 18
Note:
When using 25 mm (1 inch), 38 mm (1-1/2
inch), or occasionally 51 mm (2 inch) height-of-cut,
move the skids and gage wheels to the highest position.
Wing Mower Decks
To adjust the height-of-cut on the wing mower decks, add
or remove an equal number of spacers from the caster
forks, position the caster-wheel axles in the high or low
height-of-cut holes in the caster forks, and secure the pivot
arms to the selected height-of-cut bracket holes.
1.
Position the caster-wheel axles in the same holes in all
of the caster forks (
and
).
2.
Remove the tensioning cap from the spindle shaft and
slide the spindle out of the caster arm (
).
Figure 19
1.
Tensioning cap
4.
Top axle-mounting hole
2.
Spacers
5.
Caster wheel
3.
Shims
3.
Install 2 shims onto the spindle shaft as they were
originally installed.
Note:
These shims are required to achieve a level
across the entire width of the mower decks. Slide the
appropriate number of 13 mm (1/2 inch) spacers (refer
to the chart below) onto the spindle shaft to attain the
desired height-of-cut; then slide the washer onto the
shaft.
Refer to the following chart to determine the
combinations of spacers for the setting (
).
26
Содержание 30643
Страница 20: ...Specifications Figure 9 20...
Страница 70: ...Notes 70...