Toro 09960, Руководство оператора, Страница: 27 / 92

3. Add fuel to the fuel tank, until the level is 6 mm
to 13 mm (1/4 to 1/2 inch) below the bottom of
the filler neck.
Important:
This space in the tank allows
fuel to expand. Do not fill the fuel tank
completely full.
4. Install the fuel-tank cap securely.
5. Wipe up any spilled fuel.
Performing Daily
Maintenance
Before starting the machine each day, perform the
each Use/Daily procedure listed in
Maintenance (page
63) .
Testing the Safety Interlock
System
Service Interval: Before each use or daily
CAUTION
If safety interlock system is disconnected
or damaged, the machine could operate
unexpectedly, causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
system daily and replace any damaged
safety-interlock parts before operating the
machine.
•
The safety interlock system prevents the engine
from starting unless the traction control is in the
N
EUTRAL
position.
•
The safety interlock system prevents the engine
from starting unless the operator presence bail is
fully released.
•
The safety interlock system prevents the engine
from starting unless the coring head bail is fully
released.
•
The safety interlock system raises the coring head
and shuts it off if you drive the machine backward
while aerating or contact the bump-stop switch.
Important:
If the safety interlock system does
not operate as described, have an authorized
the manufacturer distributor repair the safety
interlock system immediately.
Raising the Coring Head
If the coring head is lowered, perform the following
steps. If the coring head is raised, skip to
Testing the
Starter Interlock (page 27) .
1. Start the engine and set the engine speed to
the S
LOW
position; refer to Starting the Engine
(page 40) .
2. Lower the handlebar ( Figure 29 ).
g339623
Figure 29
3. Press any of the buttons on the InfoCenter
(
Figure 30 ).
Note:
The coring head raises.
g339624
Figure 30
1. InfoCenter buttons
4. Shut off the engine; refer to Shutting Off the
Engine (page 40) .
Testing the Starter Interlock
1. If the engine is running, shut it off.
2. Hold either operator-presence bail to the
handlebar and rotate the traction control (
Figure
31 ) forward or rotate it backward, and start the
engine.
Important:
The engine must not start.
27