Toro 09960, Руководство оператора, Страница: 40 / 92

g339623
Figure 75
3. Release the handlebar-latch knob.
Starting the Engine
1. Fully raise and latch the handlebar engage the
parking brake; refer to
Engaging Parking Brake
(page 39) .
2. Use the choke ( Figure 76 ) as follows:
•
Before starting a cold engine, move the
choke control to the
ON
position.
•
When starting a warm or hot engine, you
may not need to use the choke.
g338575
Figure 76
1. Key (ignition switch) 3. Choke
2. Throttle lever 4. Tachometer
3. Move the throttle lever to the
FAST
position
before starting a cold engine.
4. Turn the ignition key to the S
TART
position.
When the engine starts, release the key.
Important:
Do not engage the starter for
more than 10 seconds at a time. If the engine
fails to start, allow a 30-second cool-down
period between attempts. Failure to follow
these instructions can burn out the starter
motor.
5. After the engine starts, move the choke toward
the O
FF
position. If the engine runs rough or
stalls, move the choke back toward the O
N
position for a few seconds. Then move the
throttle lever to desired engine speed.
Note:
Repeat this step as required.
Shutting Off the Engine
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always fully raise and latch the handlebar to
engage the parking brake, shut off the engine,
and remove the key when leaving the machine
unattended, even if just for a few minutes.
1. Fully raise and latch the handlebar to engage
the parking brake; refer to
Engaging Parking
Brake (page 39) .
2. Move the throttle lever ( Figure 77 ) to the S
LOW
position.
g338575
Figure 77
1. Key (ignition switch) 3. Choke
2. Throttle lever 4. Tachometer
3. Let the engine idle for 60 seconds.
4. Turn the ignition key to the O
FF
position and
remove the key.
40