Note:
The coring head lowers until it is fully
supported by the service latch.
6.
Press the center InfoCenter button until the
S
ERVICE
L
OWER
option is selected (
),
press the right button.
g359989
Figure 177
7.
Move the key to the S
TOP
position.
Note:
Start the engine and run it to raise the coring
head hydraulically so that you can stow the service
latch; refer to
Stowing the Service Latch (page 50)
.
Checking the Hydraulic
Lines
Service Interval:
Before each use or daily
Before each use, check the hydraulic tubes and hoses
for leaks, loose fittings, kinked hoses, loose mounting
supports, wear, and weather or chemical deterioration.
Make replace worn or damaged hydraulic lines before
operating the machine.
Note:
Keep the areas around the hydraulic system
clean from debris buildup.
Hydraulic Fluid
Specifications
The reservoir is filled at the factory with high-quality
hydraulic fluid. Check the level of the hydraulic fluid
before you first start the engine and daily thereafter;
refer to
Checking the Engine-Oil Level (page 72)
.
Recommended hydraulic fluid:
the manufacturer
PX Extended Life Hydraulic Fluid; available in 19 L (5
US gallon) pails or 208 L (55 US gallon) drums.
Note:
A machine using the recommended
replacement fluid requires less frequent fluid and filter
changes.
Alternative hydraulic fluids:
If the manufacturer
PX Extended Life Hydraulic Fluid is not available,
you may use another conventional, petroleum-based
hydraulic fluid having specifications that fall within the
listed range for all the following material properties
and that it meets industry standards. Do not use
synthetic fluid. Consult with your lubricant distributor
to identify a satisfactory product.
Note:
the manufacturer does not assume
responsibility for damage caused by improper
substitutions, so use products only from reputable
manufacturers who will stand behind their
recommendation.
High Viscosity Index/Low Pour Point
Anti-Wear Hydraulic Fluid, ISO VG 46
Material Properties:
Viscosity, ASTM D445
cSt @ 40°C (104°F)
44 to 48
Viscosity Index ASTM D2270
140 or higher
Pour Point, ASTM D97
-37°C to -45°C (-34°F
to -49°F)
Industry Specifications:
Eaton Vickers 694 (I-286-S,
M-2950-S/35VQ25 or
M-2952-S)
Note:
Many hydraulic fluids are almost colorless,
making it difficult to spot leaks. A red dye additive for
the hydraulic fluid is available in 20 ml (0.67 fl oz)
bottles. A bottle is sufficient for 15 to 22 L (4 to 6 US
gallons) of hydraulic fluid. Order Part No. 44-2500
from your authorized the manufacturer distributor.
Important:
the manufacturer Premium Synthetic
Biodegradable Hydraulic Fluid is the only
synthetic biodegradable fluid approved by Toro.
This fluid is compatible with the elastomers used
in Toro hydraulic systems and is suitable for a
wide-range of temperature conditions. This fluid is
compatible with conventional mineral oils, but for
maximum biodegradability and performance, the
hydraulic system should be thoroughly flushed
81
Содержание 09960
Страница 89: ...Notes...