Toro 07390 Workman HDX-Auto, Руководство по обслуживанию, Страница: 86 / 280

Workman HDX Auto Page 4 − 42 Drive Train
Installation (Fig. 45)
1. Carefully raise rear differential into machine from the
rear of the machine. Support differential in position to
prevent it from shifting or falling.
NOTE: When securing the rear differential to the ma-
chine, loosely install all fasteners before fully tightening
any of the fasteners.
2. On the sides of the rear differential, install flange
head screws that secure the differential to the engine/
transmission mount.
3. On the front of the rear differential, install two (2)
flange head screws that secure the differential to the en-
gine/transmission mount.
4. Position LH and RH rear mounts to machine frame
and rear differential and install removed fasteners to se-
cure the mounts. Make sure that solenoid controller as-
sembly (item 22) is secured to the machine frame with
fasteners for the RH rear mount.
5. Tighten all fasteners to secure rear differential to ma-
chine.
6. Install both CV axle assemblies with attached wheel
hubs to machine (see Rear CV (Constant Velocity) Axles
in this section). Make sure that flange head screws that
secure wheel hub to rear axle are torqued from 35 to 40
ft−lb (48 to 55 N−m).
7. Install rear brake rotor, brake caliper and wheel as-
sembly to both sides of machine (see Brake System in
the Service and Repairs section of Chapter 5 − Chassis).
WARNING
Failure to maintain proper wheel lug nut torque
could result in failure or loss of wheel and may
result in personal injury. Torque wheel lug nuts
from 80 to 90 ft−lb (109 to 122 N−m).
8. Make sure that rear wheel lug nuts are properly tight-
ened.
9. Connect wire harness connector to rear differential
lock solenoid on right side of differential.
10.Install parking brake rotor, rear driveshaft and park-
ing brake caliper to rear differential (see Parking Brake
Caliper in the Service and Repairs section of Chapter 5
− Chassis).
11. Make sure that all supports under the machine used
for the rear differential and engine/transmission mount
are removed before lowering the machine.
12.Lower rear of vehicle to ground.
13.Properly fill rear differential with 80W90 API GLI−5 lu-
bricant. Torque drain and fill plugs from 10 to 14 ft−lb (14
to 19 N−m).
14.Lower cargo bed (if installed).