Toro 07390 Workman HDX-Auto, Руководство по обслуживанию, Страница: 67 / 280

Workman HDX Auto Page 4 − 23 Drive Train
CAUTION
The engine, exhaust system and drive system
components may be hot. To avoid possible
burns, allow all components to cool before work-
ing on drive system components.
Removal (Fig. 26)
1. Park vehicle on a level surface, raise and support ve-
hicle cargo bed (if installed), shut engine off and engage
the parking brake. Remove key from the ignition switch.
2. Place speed range lever in the transport (T) position
to remove pressure in the speed control system.
3. Remove speed limiter assembly (item 9) with at-
tached speed control hose from primary clutch to allow
removal of CVT enclosure cover (see Speed Limiter As-
sembly in this section).
4. Remove washer head screws (items 14 and 15) that
secure CVT enclosure cover (item 13) to spanner plate
(item 16). Note that two (2) longer screws are installed
on the air intake end of the cover (Fig. 27).
5. Separate CVT enclosure cover from spanner plate
and remove from vehicle.
Installation (Fig. 26)
1. Position CVT enclosure cover to spanner plate and
secure with washer head screws (items 14 and 15).
Make sure that two (2) longer screws are installed on the
air intake end of the cover.
2. Install and secure speed limiter assembly (item 9)
with attached speed control hose to the primary clutch
(see Speed Limiter Assembly in this section).
3. Install speed limiter cover (item 7) to CVT enclosure
cover. Make sure that speed control hose (item 12) is
routed through slot in limiter cover. Secure cover with
three (3) washer head screws (item 6).
4. Bleed speed control system (see Bleed Speed Con-
trol System in this section).
5. Remove bed support from cargo bed lift cylinder and
lower bed.
Figure 27
1. CVT enclosure cover
2. Speed limiter cover 3. Longer screw (2)
1
2
3
Safety
Product Records
Drive T
rain