Toro 07390 Workman HDX-Auto, Руководство по обслуживанию, Страница: 148 / 280

Workman HDX Auto Page 5 - 46 Chassis
Removal (Fig. 38)
1. Park the machine on a level surface, shut off the en-
gine, set the parking brake, and remove the key from the
key switch.
2. Remove the wiper blade (item 15 in Fig. 38) from the
wiper arm.
3. If necessary, remove the wiper arm as follows:
A. Disconnect the washer hose from the wiper arm.
B. Lift the cap at the top of the wiper arm and remove
the wiper stud nut that secure the wiper arm to the
wiper motor.
C. Use a suitable puller to remove the tapered wiper
arm socket from the wiper motor shaft.
4. If access to the wiper motor is necessary, do as fol-
lows:
A. Remove the 10 clips, 10 sealing washers, and 10
flange- head screws that secure the roof to the cab
frame, and remove the roof.
B. Remove the console foam.
5. Remove the wiper motor components as shown in
Figure 38.
Installation (Fig. 38)
1. Locate the nuts on the studs at the dimensions
shown before assembling the wiper motor into the con-
sole (Fig. 39).
2. Install the wiper motor components that were re-
moved (Fig. 38) and do the following:
A. Ensure that the wiper motor electrical connector
is secured to the cab wire harness.
B. Position the console foam. Secure the roof to the
cab frame with the 10 clips, 10 sealing washers, and
10 flange- head screws.
Figure 39
3.05 mm
(0.12 inch)
3.05 mm
(0.12 inch)
3. If the wiper arm was removed, do the following:
A. Clean the tapered wiper arm socket and wiper
motor shaft.
B. Slide the wiper arm socket onto the wiper motor
shaft and secure the wiper arm socket with the wiper
stud nut. Install the wiper arm cap over the wiper stud
nut.
4. If the wiper blade was removed, secure the blade to
the wiper arm.