4.
Tighten the jam nuts until the outside thrust
washers just rotate freely.
5.
Tighten the spring-tension nut until the spring is
collapsed, then back it off 1/2 turn.
6.
Adjust the bedbar; refer to
Bedknife to the Reel (page 36)
.
Backlapping the Reel
1.
Remove the plug in the right reel-drive cover
(
).
g007633
Figure 63
1.
Cover plug
2.
Insert a 1/2 inch-drive extension bar, connected
to the backlapping machine, into the square hole
in the center of the reel pulley.
3.
Backlap according to the procedure in the Toro
Sharpening Reel and Rotary Mowers Manual
,
Form 80-300 PT.
DANGER
Contact with the reel or other moving
parts can result in personal injury.
•
Stay away from the reel while
backlapping.
•
Do not use a short-handled paint
brush for backlapping. Part No.
29-9100 Handle assembly, complete or
as individual parts, are available from
your local authorized Toro distributor.
Note:
For a better cutting edge, run a file
across the front face of the bedknife when the
lapping operation is completed. This removes
any burrs or rough edges that may have built
up on the cutting edge.
4.
Install the plug in the cover when you complete
this procedure.
40
