Toro 04054 Greensmaster 800, Руководство оператора

Страница: 39 / 44

Adjusting the Cut-Off Bar
Adjust the cut-off bar to ensure that the clippings are
cleanly discharged from the reel area.
1. Loosen the screws that secure the top bar
(
Figure 59 ) to the cutting unit.
g027395
Figure 59
1. Cut-off bar
2. Insert a 1.5 mm (0.060 inch) feeler gauge
between the top of the reel and the bar and
tighten the screws.
3. Ensure that the bar and reel are equal distances
apart across the entire reel.
Note:
The bar is adjustable to compensate
for changes in turf conditions. Adjust the bar
closer to the reel when the turf is extremely wet.
By contrast, adjust the bar further away from
the reel when turf conditions are dry. The bar
should be parallel to the reel to ensure optimum
performance. Adjust the bar when you adjust
the shield height or when you sharpen the reel
on a reel grinder.
Identifying the Bedbar
To determine if the bedbar is standard or aggressive,
check the left bedbar mounting ears. If the mounting
ears are rounded, it is a standard bedbar. If the
mounting ears have a notch in them, it is an
aggressive bedbar (
Figure 60 ).
g008800
Figure 60
1. Standard bedbar 2. Aggressive bedbar
Servicing the Bedbar
Removing the Bedbar
1. Turn the bedbar-adjuster screw
counterclockwise to back the bedknife
away from the reel (
Figure 61 ).
g007631
Figure 61
1. Bedbar-adjusting screw 3. Bedbar
2. Spring-tension nut
2. Back out the spring-tension nut until the washer
is no longer tensioned against the bedbar
(
Figure 61 ).
3. On each side of the machine, loosen the jam nut
that secures the bedbar bolt (
Figure 62 ).
g014780
Figure 62
1. Jam nut 2. Bedbar bolt
4. Remove each bedbar bolt allowing the bedbar
to be pulled downward and removed from the
machine. Save the 2 nylon and 2 stamped steel
washers on each end of the bedbar (
Figure 62 ).
Installing the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and the bedbar adjuster.
2. Secure the bedbar to each side plate with the
bedbar bolts (jam nuts on the bolts) and 8
washers.
Note:
Position a nylon washer on each side
of the side plate boss. Place a steel washer
outside each of the nylon washers.
3. Torque the bolts to 27 to 36 N∙m (20 to 27 ft-lb).
39