Toro 03188, Руководство оператора

Страница: 19 / 26

Installing the Front Shaft
Assembly for Reel Grinding
Model 03192 Only
Important:
You must order the following parts so
that the cutting unit can be fitted to a reel grinding
machine:
Qty. Part Part No.
2 Front HOC bracket 125-2796
2 Carriage bolt (3/8 x 1-1/2
inches) 3231-4
2 Locknut (3/8 inch) 104-8301
2 Hex-head bolt (5/16 x
1-1/8 inches) 322-16
1 Front roller shaft 117-0957
1. Remove the shop roller assemblies (if equipped);
refer to
Adjusting the Shop Roller Assemblies
(page 11) .
2. Using the carriage bolts and locknuts, install
front HoC brackets to the top hole of the side
plate (
Figure 27 ).
Important:
Ensure that the HOC bracket is
installed with the carriage bolt at the top of
the slot, so that the HOC bracket is as low
as possible.
g361153
Figure 27
1. Carriage bolt (3/8 x 1-1/2
inches) 4. Hex-head bolt (5/16 x
1-1/8 inches)
2. Front roller shaft 5. Locknut (3/8 inch)
3. Front HOC bracket
3. Install the shaft to the bottom of the HOC
brackets using the 2 hex-head bolts.
4. Ensure that the shaft is parallel to the cutting
unit; if it is not, loosen the carriage bolt on the
low side and tighten it again when the shaft is
parallel.
19