Toro 03188, Руководство оператора

Страница: 12 / 26

Adjusting the Height of Cut
(HOC)
Models 03188, 03189, 03190, and
03191 Only
Note:
Use Height-of-Cut Chart (Models 03188,
03189, 03190, and 03191) to determine the
number of rear spacers needed for the desired
aggressiveness-of-cut setting; refer to
Height-of-Cut
Chart (Models 03188, 03189, 03190, and 03191)
(page 13)
.
1. Loosen the locknuts securing the height-of-cut
brackets to the cutting-unit side plates (
Figure
15 ).
g015089
Figure 15
1. Adjusting screw 3. Height-of-cut bracket
2. Locknut
2. Loosen the nut on the gauge bar ( Figure 16 )
and set the adjusting screw to the desired height
of cut.
Note:
The distance between the bottom of the
screw head and the face of the bar is the height
of cut.
g011864
Figure 16
1. Gauge bar 3. Nut
2. Height-adjusting screw
3. Hook the screw head on the cutting edge of the
bedknife and rest the rear end of the bar on the
rear roller (
Figure 17 ).
4. Rotate the adjusting screw until the front roller
contacts the gauge bar (
Figure 17 ). Adjust both
ends of roller until the entire roller is parallel to
the bedknife.
g011865
Figure 17
Important:
When set properly, the rear
and front rollers will contact the gauge
bar and the screw will be snug against the
bedknife. This ensures that the height-of-cut
is identical at both ends of the bedknife.
5. Tighten the nuts to secure adjustment.
Note:
Do not overtighten the nuts. Tighten
them just enough to remove any play from the
washer.
12