Toro 02000 GROUNDS PRO 2000, Руководство оператора

Страница: 33 / 36

Figure 46
Figure 47
1. Bedbar adjuster
2. Carriage bolts
3. Adjustment nuts
VERIFYING HEIGHT-OF-CUT
SETTING (Fig. 48)
(Floating Cutting Unit)
1. On a gauge bar, set the head of the screw to the
desired height of cut. This measurement is from the
bar face to the underside of the screw head. A gauge
bar (Toro Part No. 13-8199) may be obtained from
your local TORO Distributor.
Figure 48
1. Gauge bar
2. Front roller support screw
2. Slightly loosen the nut securing each front roller
bracket to the angle bracket.
3. Place the bar across the front and rear rollers and
adjust the front roller support screws until the
underside of the screw head engages the bedknife
cutting edge. Do this on both ends of the reel.
4. Tighten the nuts securing the roller brackets.
IDENTIFICATION AND ORDERING
MODEL AND SERIAL NUMBER
The mower has two identification numbers: a model
number and a serial number. The two numbers are
stamped into a plate that is riveted to the frame. In any
correspondence concerning the mower, supply the model
and serial numbers to assure that correct information and
replacement parts are obtained.
Note
: Do not order by reference number if a parts
catalog is being used; use the part number.
To order replacement parts from an Authorized TORO
Service Dealer, supply the following information:
1. Model and serial numbers of the mower.
2. Part number, description and quantity of part(s)
desired.
Maintenance
33