Toro 02000 GROUNDS PRO 2000, Руководство оператора

Страница: 24 / 36

Maintenance
24
2. Remove the wing nut securing the elements to the
air cleaner body.
3. If the foam element is dirty, remove it from the
paper element. Clean thoroughly.
Figure 30
1. Foam element
2. Paper element
A. WASH the foam element in a solution of liquid
soap and warm water. Squeeze to remove dirt,
but do not twist because foam may tear.
B. DRY by wrapping in a clean cloth. Squeeze the
cloth and foam element to dry.
C. SATURATE the element with clean engine oil.
Squeeze element to remove excess oil and to
distribute the oil thoroughly. An oil damp
element is desirable.
4. When servicing the foam element, check condition
of the paper element. Clean by gently tapping it on
a flat surface or replace as required.
5. Install foam element, paper element and air cleaner
cover.
IMPORTANT:
Do not operate the engine without air
the cleaner element because extreme engine wear and
damage will likely result.
ADJUSTING THE THROTTLE
CONTROL (Fig. 31)
Proper throttle operation depends upon proper
adjustment of the throttle control. Before adjusting the
carburetor, assure the throttle control is operating
properly.
1. Loosen cable clamp screw securing the cable to the
engine.
2. Move the remote throttle control lever forward to
FAST position.
3. Pull firmly on the throttle cable until back of swivel
contacts stop.
Figure 31
1. Throttle cable
2. Choke cable
4. Tighten cable clamp screw and check the engine
RPM setting.
High Idle: 3200 + 50 –100
Low Idle: 1400 ± 50
The engine must be running during adjustment of
the carburetor and speed control. To guard against
possible personal injury, shift into neutral, and
engage the parking brake. Keep hands, feet, face,
and other parts of the body away from the cutter
blades, and any rotating engine parts.
WARNING
1
1
2
2