Installation Instructions
20 - 30 Wide
Install Hip Pole Brace Bars
Connect the upper end of the hip pole brace, as shown, to
the hip splice connector with a 3/8" D-Clasp pin. Hold
pole firmly so that it will not drop (this could damage the
eye end).
Then, connect the hip pole brace to the intermediate
bracket, as shown, using a 3/8" D-Clasp pin. It may be
necessary to push up on the hip pole to locate the D-Clasp
pin and lock the hip pole in place. Repeat this procedure
for the remaining hip pole braces
View of completed end frame with hip pole braces in
place. Please note: The 20 wide Future Lite will have a
single piece hip pole and that hip pole braces are not
required.
Note: Now is the time to check that the frame is square with the
installation site. Shift as necessary to properly align before
completing the frame assembly. Remember, as you add
components the frame becomes heavier and more rigid making it
difficult to move around.
To add mid section to end frame, connect the two
perimeter poles to the completed half of the end frame.
This will establish the location for alignment of the next
arch assembly.
D-Clasp Brace Bar
to Connector
Keder Rafter
Intermediate
Bracket
D-Clasp Pin
QUICK PIN
QUICK PIN
Adding Mid Section
( 5 )
AIFL 2030 1101