Topper 20-209-001, Инструкция по установке и эксплуатации, Страница: 18 / 48

18
Final Inspection—Important
After going to the Installation Manual and following directions on pages 13, 14, 15.
Start your system and ensure that your installation is completely (leak free) and making water,
make sure to completely wipe down the system and make sure the system is dry, prior to installing
leak pads, to ensure leak pads do not swell, shutting system off.
Install Leak Pads
After determining system is dry and operational, install leak pads by flipping the leak switch in the
OFF position and placing the pad in it
’ s position. Now flip leak switch in the ON position.
NOTE:
Be sure to remove the leak pad from it ’ s plastic wrapping.
If any moisture is present, the leak pad will soak it up and trigger the switch and shut off the
system.
Filter Change Page 32 in User Manual
Remove leak pad before servicing system with filter changes.
A. First flip leak switch in the ‘ OFF ’ position.
B. Use any needle to be pressed into the pad to easily remove the pad.
C. Make your service changes and restart machine following the user manual , page 15 - A, B, C, D
and E. Be sure to lower the leak detector lever turning system on.
D. Once system is in working order, making sure system pool is completely dry. Lift lever of leak
switch and place leak pad back into detector and closed switch to the
‘ ON ’ position.
Step 4
Step 5
Step 6
Troubleshooting
PROBLEM REASON SOLUTION
System won ’ t make water
Leak switch has been triggered to the
‘ OFF ’ position.
Remove swollen leak pad, switch to the ‘ ON ’
position and investigate for a leak and repair.
After repair, replace leak pad and restart.
NOTE:
It is possible that leaks from other appliances or other water sources may be received into the leak sys-
tem pool, triggering the system in the
‘ OFF ’ position.
Customer should investigate then make the appropriate calls.