Topper 20-209-001, Инструкция по установке и эксплуатации, Страница: 14 / 48

14
Connect the System
WOW RO System port identification markings molded into the top of
the manifold: (See Figure 4).
•
F: Feed (¼ ” red)
•
D: Drain (¼ ” black)
•
FA1: Faucet/Accessory 1 (⅜ ” blue)
•
FA2: Faucet/Accessory 2 (¼ ” blue)
•
PW: Used for testing or additional storage.
•
SQ: Used for testing or additional storage.
•
RF: Do not touch (pre - connected).
NOTE: Ports that are not used require the appropriate sized plug.
(Included).
A. With the WOW RO System in place, remove any port plugs as necessary (push in the white col-
let to release) and make the following connections:
B. Feed F connection: Take the 1/4” red tubing and snip off a 6” length. Take the long end of re-
maining tubing and attach it to the Primary Shut - Off Valve (cold water supply). Attach other end
to the WOW RO System Emergency Shut - Off Valve (in installation kit). With the 6” tubing,
attach one end to the WOW RO System Emergency Shut - Off Valve and the other end to the gray
“ F ” port (See Figure 1, Page 3: Installation Diagram).
C. Drain D connection:
i. Air - Gap Faucet
Route the free end of the 1/4” black tubing attached to the RO faucet air - gap to the connec-
tion marked “ D ”. Air - gap faucet, (See Figure 12, Page 29).
ii. Non Air - Gap Faucet *
Route the drain line connection (saddle clamp or other) to the connection marked “ D ”, us-
ing the 1/4” black tubing.
* Check local plumbing codes for compliance when using non air - gap faucets.
D. RO Faucet connection:
FA1 (3/8”) or FA2 (1/4”) If there are no additional appliances (i.e. refrigerator/icemaker, coffee
maker, cooler, etc.) to install then you have the choice of using either port for the RO faucet.
i. If the RO faucet is more than ten feet in distance from the WOW RO System , then the 3/8”
FA1 port is preferred.
ii. Use the 1/4” FA2 port for the RO faucet and the 3/8” FA1 port for refrigerators/icemakers
etc.
Note: For connecting a REFRIGERATOR/ ICEMAKER, you MUST add a ball valve (isolation valve) to properly initiate
the start
- up. See Section 2, Pages 16 - 23.
Installation Steps and Start - Up Procedures
Step 4
Figure 4:
System Connections