Topp Music Gear MXi.1222CFX, Руководство пользователя

Страница: 12 / 24

Ok, you have got to this point and you are now in the position to successfully operate your 12 /
14 / 16 Channel Mixing Console. However, we advise you to read carefully the following section
to be the real master of your own mixer. Not paying enough attention to the input signal level,
to the routing of the signal and the assignment of the signal will result in unwanted distortion, a
corrupted signal or no sound at all. So you should follow these procedures for every single
channel:
• Before connecting MICs or instruments, make sure that the power of all your systems
components including the mixer is turned off. Also, make sure that all input and output
controls of your mixer are turned down. This will avoid damage to your speakers and avoid
excessive noise.
• Properly connect all external devices such as MICs, power amplifiers, speakers, effect processor
etc.
• Now, turn on the power of any peripheral devices, then power up the mixer.
Note: the power amplifier or powered monitors shall be turned on after the mixer and turned off
before the mixer.
• Set the output level of your mixer or the connected power amplifier at no more than 75%.
• Set the CONTROL ROOM/PHONE level at no more than 50%.
• Position HI, MID and LOW EQ controls on middle position.
• Position panoramic (PAN/BAL) control on center position.
• While speaking into the MIC (or playing the instrument ), adjust the channel Level control so
that the PEAK LED will blink occasionally, in this way you will maintain good headroom and
idea dynamic range.
• You can shape the tone of each channel by adjusting the equalizer controls as desired.
• Now repeat the same sequence for all input channels. The main LED could move up into the red
section, in this case yo can adjust the overall output level through the MAIN MIX control.
Some Final Tips on Wiring Configuration
You can connect unbalanced equipment to balanced inputs and outputs. Simply follow these
schematics.
Installation And Connection
12
5