Topp Music Gear MXi.1222CFX, Руководство пользователя

Страница: 7 / 24

13. AUX SEND CONTROLS
These four controls are used to adjust the level of the respective signal sent to AUX bus and
their adjustable range is from -∞ to +10 dB .
14. PRE/POST
AUX1 and AUX2 can be switched to PRE/POST-FADER via the PRE/POST
button, so, generally, they can be used for monitor application and effects
& sound processors input. AUX3 and AUX4 are configured as POST-Faders.
15. PAN / BAL CONTROL.
The PAN control determines the stereo positioning of the channel signal on
the stereo L and R buses.The BAL control knob sets the balance between
left and right channels. Signal input through the stereo L/R bus.
16. MUTE
Each channel is equipped with the MUTE button, pressing this button is
equal to turning the fader down, which can mute the corresponding
channel output except for the PRE AUX sends, channel INSERT send and
PFL, and the MUTE LED will illuminate.
17. SIG/CLIP
Indicate that the channel's incoming audio signal is with in an optimal
range.
18. CHANNEL LEVEL
This fader will adjust the overall level of this channel and set the amount of signal sent to the
main output.
19. GR1-2/GR 3-4/L-R
Each channel provides three push-buttons: GR1-2, GR3-4, L-R . The three buttons can be
considered as signal assignment switches. Pressing the GR1-2 will assign the channel signal to
GROUP1-2, you can depend on the PAN switch to adjust the amount of channel signal sent to the
GR1versus GR2, when turns the PAN to completely left, then the signal can be only controlled
by GROUP1 and viceversa. In the same way, pressing the GR3-4 or L-R will assign the channel
signal to GROUP3-4 or MAIN MIX L-R, and will also be affected by PAN.
20. PFL
Each channel is equipped with the PFL button, pressing this button which the corresponding
signal send will be routed to CTRL ROOM/PHONES outputs and METER display.
21. GROUPS LEVEL
These faders are used to control the levels of the signal send to the GROUPS OUT, the
adjustable range goes from -∞ to +10 dB. Any channel that is assigned to the groups, not muted
and not turned down will be assigned to the GROUPS OUT.
7
Control Elements
13
14
15
19
16
17
18
20
4