20
Note: Using of the exit wand, keypad and external receiver would cause the battery exhausted quickly.
Big capacity of battery and big power of solar panel (if the solar panel is used as main charger) is
required if you want to use either of them.
How to Program the Remote to the Opener
The remote MUST be programmed to the opener BEFORE OPERATING. Please follow the steps to
program the remote.
Activate the opener only when gate is in full view, free of obstruction and properly adjusted. No one
should enter or leave gate area while gate is in motion. DO NOT ALLOW CHILDREN to operate push
button or remote. DO NOT ALLOW CHILDREN TO PLAY NEAR THE GATE.
If you purchase additional remote controls, the gate opener must be programmed to accept the new
remote code.
If you lose one of any remote control, please erase and reprogram all other remote controls to have a
new code for safety.
Press and release the
CODE SW
button, the
CODE
LED will be ON
,
then press the key on the remote
two
times
in 2 seconds,
between the two times HOLD ON FOR A MOMENT
, the
CODE
LED will flash for 3
seconds and then to OFF. Now the remote has been programmed successfully.
NOTE: Max. 8 remotes can be programmed for the opener. An External Receiver (optional) allows up to
250pcs remotes to be programmed for the opener. TOPENS ERM12 Universal External Receiver is
available at TOPENS Store.
TOPENS ERM12 Universal External Receiver is also compatible with other brand swing gate opener,
sliding gate opener and garage door opener.
How to Erase All the Remote Codes
Press and hold the
CODE SW
button until the
CODE
LED from ON to OFF. Now all remote codes have been
erased.
How to Use the Remote to Operate Your Gate Opener
Each remote has four buttons, from top to bottom are separately A, B, C and D. You may use this remote to
operate as many as 4 sets TOPENS swing gate openers or 1 set TOPENS sliding gate opener and 2 sets
TOPENS swing gate openers.
