Topcon System 350, Руководство оператора

Страница: 75 / 112

Chapter 4 - Operations 4.2 Opening Auto Section Control
X30 Spreader Controller
4-5
2. Select Control Mode to avoid overlap or avoid gaps. If
Avoid Gaps is chosen, some overlap of application is
likely near boundaries. If Avoid Overlap is chosen, there
may be some spaces where product is not applied.
3. Choose and Confirm.
4. Select Gap Size to adjust the size of gaps, if needed.
5. Enter the preferred gap size and Confirm.
6. Select Boundary Limit. This sets which type of boundary
limit will turn off spreading using Auto Section Control.
Field Boundary and Headland are defined using the Field
Menu on the Operations Screen. Refer to the Guidance and
Auto Steering Operator’s Manual for more information on
these.
Safety Zone reduces width of spreading by half a swath
width from the boundary to prevent overspread.