Topcon System 350, Руководство оператора

Страница: 20 / 112

X30 Spreader Controller
1-1
Chapter 1 - Introduction
The X30 Spreader and Auto Section Controller is used with
the X30 Guidance and Auto Steering Console. Refer also to
the X30 Guidance and Auto Steering Operator's Manual.
The X30 Spreader Controller allows better control of the
amount of product being applied to a field. Once set up, it
will adjust the discharge rate according to vehicle speed and
the section being covered to maintain the preset application
rate. This provides more accurate use of a product over the
specified areas.
Auto Section Control minimizes wastage, turning parts of the
spreader on and off as the equipment passes through the
defined areas. The system will turn on when it detects an area
that has not been covered and it will turn off when it detects
areas that have already had product applied.
Section control is limited to the number of spinners being
controlled by the X30 Spreader Controller. In a two spinner
setup, there can be two sections (left and right). In a single
spinner setup, there is only one section which is the entire
working width of the spreader.
Regional information such as time and product
measurement units can be set by selecting User from the
Main Setup Menu
. Refer to the X30 Guidance and
Auto Steering Manual.
The console will ask you to confirm your selections:
Confirm the selection/action to continue.
Cancel the selection/action and return to previous screen.