Topcon SR-NIR, Инструкция по эксплуатации

Страница: 35 / 86

23
3.1.2 Entering/Returning from the Function Mode
■
Function menu
Using the function mode, perform a variety of settings.
Shifting to the function mode and the setting items are
described below.
Make sure that the instrument is in the standby condition.
Then, press the [FUNCTION] panel switch for about 2
seconds. When you hear the beep sound, release the
switch.
The system shifts to the function mode.
Note
If you release the switch before the beep sound occurs, the system does not shift to the
function mode. Be sure to keep pressing the switch until the beep sound occurs.
When pressing the [ROTATION] switch or [CHANGE] switch on the panel, “*” is moved. Fit “*” to a
desired item and press the [ENTER] switch to decide the item. The setting items in each function
mode are displayed.
The setting items of each function mode are described below.
(1) MEASURE: This is relevant to measurement.
○
1
Measure Type : Set the measurement mode.
☞
“3.2 Measurement Mode”.
○
2
Frequency Input :
Set the frequency for “FREQ” measurement mode. When
“FREQ” is selected in
○
1
of (1), this item is displayed.
☞
“3.2.1 FREQ (Frequency) Mode”.
○
3
Integ Time Input :
Set the integral time for “MANU” mode. When “MANU” is
selected in
○
1
of (1), this item is displayed.
☞
“3.2.2 MANU (Manual) Mode”.
○
4
Integ Delay ON/OFF :
Set “Valid/Invalid” of the integral time delay function.
☞
“3.3 Integral Time Delay Function”.
＊ＭＥＡＳＵＲＥ MAINTAIN
ＦＡＣＴＯＲ
ＣＯＭＭ．
ＤＩＳＰＬＡＹ
Function mode menu screen
ENTER
DIF.
ABS.
UP
LAMP
DOWN
MEAS.
HOLD
FIELD
CHANGE ROTATION
SHIFT
FUNCTION