Top Notch Products MINI SUPREME, Руководство пользователя

Страница: 17 / 38

15
c
20
c
19
c
18
c
17
c
16
c
15
c
13
c
12
c
11
c
10
c
9
Cut two 11-5/8” pieces of 3/16” square bal-
sa stick and glue them to the top inside
edge from former D back to the stabilizer
area.
The photo above illustrates several steps
Locate formers F, G and H as well as the
Aft Fuselage Bottom (AFB). Install but do
not glue formers F, G and H into the fuse-
lage.
Step 9 Step 12
Step 10 &11
Install AFB, when all formers are bottomed
in their respective slots and AFB is flush
with the bottom of the fuselage, apply glue
to all formers and AFB.
Locate the Temporary Guide (Temp Guide)
and tack glue it to the back of former E.
This will support E1 At the correct angle
until the stringers are installed and then it
will be removed.
Install and glue E1 to the top of former E.
c
14
Cut two pieces of 3/16” square balsa to
11” long and install and glue them into the
notches provided in formers E1, F, G and H.
When the glue has set, remove the TEMP
GUIDE.
Step 13
Step 14
Locate the Turtle Deck Sheeting (TDS).
Install and glue it to the aft top fuselage.
The sheeting will sit on top of the fuselage
sides.
Illustrated above are installation of split former E1(step 13)
and the 3/16” stringers (step 14). Note that the TEMP GUIDE
has been removed.
Trim and sand the excess material of TDS
down just until you come in contact with
the top of the formers. It must be flat, use a
sanding bar.
Install and glue the Turtle Deck Top (TDT).
Sand the TDT and TDS until they are flush
with E1 at the front.
Sand TDT and TDS until they are flush with
former H at the back.
Next you will plane and sand TDT to shape
to form the turtle deck. Use Template A at
the front and Template B at the aft end to
mark the guide lines for shaping TDT.
Template A is used at E1 and template B is used at former H.
These are guide lines for shaping the turtle deck.