Top Notch Products MINI SUPREME, Руководство пользователя

Страница: 15 / 38

13
c
18
c
17
Trim the axle so when installed to the wheel
pant, it almost touches the opposite (out-
board) side of the wheel pant.
Assemble the gear assembly to the wheel
pant with four #1 x 3/8” sheet metal screws.
When doing this side the axle support but-
ton onto the axle on the inside of the wheel
pant and glue it to the outboard side of the
wheel pant.
c
2
c
1
c
19
c
16
The gear leg assembly is attached to the wheel pant with
four #1 x 3/8” sheet metal screws. Trim the axle just shy of
touching the opposite side and then install the axle support
button.
Install and glue WPB-8 to WPB-9.
Glue WPB8 to WPB9
Remove the four screws and install the
wheel, then reinstall the four screws.
Final installation of the mains gear will be done
after covering the wing
FUSELAGE ASSEMBLY
Locate and prepare the two fuselage sides
(FS) and the two 1/64” ply fuselage dou-
blers (FD). Do not use a water based glue
such as carpenters glue to glue these two
components together. The moisture will
warp them and render them useless.
Use Epoxy or slow setting CA and glue the
doublers (FD) to the fuselage sides (FS).
Be sure to make a left and a right. Use a
piece of 1/8” dowel in the registration holes
to get perfect alignment.
Plywood doublers are glued to the fuselage sides using the
1/8” dowels for registration.