Top Gun 351 SWF, Руководство пользователя

Страница: 22 / 32

20
Connect the earth lead connector to the negative (-) quick-connection terminal, and turn clockwise to tighten.
CAUTION: Make sure of the above connection for direct polarity welding; for inverse/reverse polarity , invert the connection: earth lead
CONNECTOR to the quick-connection positive (+) terminal.
• Check and connect all fittings.(gas , interconnecting leads etc)
• Select MIG mode on power source.
• Install correct wire and wire rollers to wire-feeder.
• Check settings and setup parameters as required.(select P1for manual operation or P* for synergic operation)
• Connect earth lead to work-piece or bench. ****See below for how to operate in synergic mode
The TOPGUN 351F and 505F, are able to be operated in “SYNERGIC” mode.
In this mode, only one parameter is necessary to control the welder and is controlled by a single dial. (Amperage/Wire speed.)
1. To Enter this mode, you will need to first select the mode required (listed on the inside of the wire-feeder door, and under the correct
machine), by depressing the large left hand Dial on the wire-feeder face/control panel until the display indicator L.E.D is lit under the
letter “P”, and then scrolling to the desired program (clockwise = higher and anti-clockwise to lower)
2. When your selection has been made, Press the button one more time to save. Once the above step is completed, you will control the
welding power of the machine with the Large Middle Dial. (Clockwise to increase welding power and wire speed, and anti-clockwise to
decrease welding power and wire speed simultaneously.)((SYNERGIC))
“P1” is manual mode and the default setting to control each parameter manually.
•
Please note that when in P1, you will need to control both welding voltage and also amperage/wire-speed manually.
Negative (Reverse) Polarity Positive Polarity
MIG
SYNERGIC OPERATION
Mode Selection
And Operation