19
Please read and understand the below BEFORE installation and operation.
This machine uses electricity and as such should be treated with respect.
Please visually check over the machine and only set up and use in a safe work area.
Please check the following:
•
Check for damage externally on welder.
•
All cords in good condition and connected properly.
•
Power supply is correct for the application.
•
No flammable items within safe distance.
•
Good ventilation.
•
Correct PPE and safety precautions in use.
•
User is familiar with the operation of this machine.
Safe Machine Installation
Machine Operation (MIG)
•
Turn machine ON.
(“On and off” switch located on front panel)
•
Preset the welding voltage and wire speed/current.(MIG)
•
Select correct program (Program 1for manual mode)((Synergic programs found on the inside of wire-feeder
door))
•
Ensure cooling mode is in gas/air unless a water cooler is installed.
•
Preset trigger mode ( 2t or 4t)
•
Check that correct rollers for wire are installed and correctly fitted..
•
Check welding wire is correctly fed through the torch with no interruption.
•
Check roller tension is correct.
(If tension too low -may feed too slowly or incorrectly )
(If too high -may cut wire or have feed issues including birds-nesting)
•
If using gas, check gas is flowing freely when the trigger is pressed and stopping shortly after releasing the
trigger.(rule of thumb is gas flow in litres to be 10 x diameter of the wire)
•
Ensure torch is as straight as possible as sharp bends or “kinks” may affect the feed of the wire through the
liner.
•
Confirm Pre-gas, Post-gas, Soft-start and Burn-back parameters are correct.
•
Connect Earth lead to the workpiece or to the bench.
•
Check operation of trigger and torch, ensure wire is feeding and gas flows through torch.
•
Check the workspace for hazards and ensure a clean and tidy work area.
Содержание 351 SWF
