Top Flite GIANT SCALE GOLD EDITION ZERO, Инструкция по эксплуатации

Страница: 33 / 40

33
❏
2. Be certain the model is clean and free from oily
fi ngerprints and dust. Prepare a dishpan or small bucket
with a mixture of liquid dish soap and warm water—about
one teaspoon of soap per gallon of water. Submerse
the decal in the soap and water and peel off the paper
backing.
Note: Even though the decals have a “sticky-
back” and are not the water transfer type, submersing
them in soap & water allows accurate positioning and
reduces air bubbles underneath.
❏
3. Position the decals on the model where desired.
Holding the decal down, use a paper towel to wipe most
of the water away.
❏
4. Use a piece of soft balsa or something similar to
squeegee remaining water from under the decal. Apply
the rest of the decals the same way.
❏
5. We have included a small piece of Olive Drab
covering. This can be applied over the access hole in the
tail cone with a covering iron set to medium heat setting.
INSTALL THE PROP AND SPINNER
❏
1. Drill the required mounting holes in the propeller.
❏
2. Install the prop and spinner. Be sure to apply
thread locker to the spinner bolt.
GET THE MODEL READY TO FLY
CHECK THE CONTROL DIRECTIONS
❏
1. Turn on the transmitter and receiver and center
the trims. If necessary, remove the servo arms from
the servos and reposition them so they are centered.
Reinstall the screws that hold on the servo arms.
❏
2. With the transmitter and receiver still on, check
all the control surfaces to see if they are centered. If
necessary, adjust the clevises on the pushrods to center
the control surfaces.
❏
1. Remove the decals from the sheet.
❏
17. Allow the glue to harden.
APPLY THE DECALS
Refer to these pictures and the pictures on the box to
determine the location for the decals. Use the following
instructions to apply the decals.